#Osculator tutorial how to
#Osculator tutorial software

The figure below represents the block diagram of an oscillator: Thereby generating waveforms such as a square wave, sawtooth wave etc.Īs we have discussed earlier that an oscillator is nothing but a combination of amplifier along with a positive feedback circuit. Non-sinusoidal or Relaxation Oscillator: In this case, the achieved signal at the output of oscillator shows a quick rise and fall at different voltage levels.Sinusoidal or Harmonic Oscillator: Here the achieved signal at the output of oscillator shows continuous sinusoidal variation as a function of time.The oscillator is mainly classified on the basis of the signal generated at its output: However, oscillator simply requires dc voltage in order to produce ac signal of desired frequency. We are already aware of the fact that an amplifier needs ac input signal that is amplified and achieved at the output of the amplifier. The frequency ranges of the ac signal at the output of oscillator ranges from a few Hz to several GHz. But more specifically, oscillators are energy converter that transforms dc energy into equivalent ac energy. That means that TouchOSC and Live are synchronized both ways.At the time of defining, we say oscillators are generators. If you click the volume fader in Live, you will notice OSCulator will automatically detect a MIDI message and will convert it to an OSC message that it sends to TouchOSC running on your iPhone. Leave MIDI learn mode by click on the MIDI button upper right.A “1/0” label is now displayed next to the volume fader, like this: This will forward the event to Live, which will learn that we want to use the MIDI control change 0 to control the volume fader. In TouchOSC, touch the yellow slider again.Click on the volume fader of the first track.Return to Live, and click on the MIDI button, located upper right.This procedure also works for any button or control in Live. Now, let’s tell Live we want to use this MIDI control change to control the volume fader of the first track. In OSCulator, select “MIDI CC” as Event Type, and “0” as Value (well, the first value in the list).The event “/1/fader” should appear in the main window of OSCulator.Touch the yellow slider to send an initial event.We will configure the yellow slider so it can control the volume of the first track in Live:

#Osculator tutorial how to

You can also learn how to make such a template by reading what’s following. Set the “Default Host” to the one corresponding to your iPhone (it should read ‘TouchOSC’ in the name). Once you’ve loaded a template file, click on the Parameters button on the toolbar and go to the OSC Hosts tab. It is located in the Sample Patches folder of the OSCulator folder you installed on your computer. If you prefer to “plug and play” with MIDI, just use the template corresponding to the layou you chose (Beatmachine in our case). Click on the “Done” button and leave TouchOSC running.įrom there, we can either load a template or configure OSCulator manually.

Select a layout, we will use “Beatmachine”.

From there your settings page should look like this (your “Host” field can be different, due to network configuration differences).

This can be actually any port number you wish.

In the “Port (incoming)” field, enter 9000.

TouchOSC will automatically fill the fields required for the network communications.

Click on the button under “Network” and choose the option corresponding to OSCulator (see picture above).

Please make sure you have latest version installed. This will enable us to record events and send control events to OSCulator as well. In Live, open the Preferences, go to “MIDI Sync” tab and enable the Track and Remote columns for “OSCulator Out” and “OSCulator In” interfaces.

#Osculator tutorial software

This tutorial explains how to control a MIDI enabled software like Ableton Live from your iPhone.